Arduino MEGA Microcontroller
Solartracker Nextion-Version 1.2, Pinbelegung am Arduino MEGA
D9 Servo Signal-Pin : Servo-Steuerleitung
Vin: Stromversorgung des Servos, ca. 7.5 Volt DC
D4: grüne LED (Drehteller vorwärts)
D6: blaue LED (Drehteller schnell rückwärts in Startposition)
D7 rote LED (Drehteller rückwärts)IN2: Hall-Drehwinkelsensor (für Azimut), 3-polig (GND, Signal, +5V)
A15: 3-Volt-Solarpanel (Pluspol, GND)
A/B: Motorshield: Anschluss Schrittmotor, 4-polig
Kabel: B = grün+schwarz, A = blau+rot
Tx2: Anschluss Rx vom Nextion-Display
Rx2: Anschluss Tx vom Nextion-Display
TWI Anschluss DS3231 RTC Echtzeituhr (GND, +5V, SDA, SCL)
Arduino-Motor-Shield REF. 3
,
Nextion-touchscreen-Display
Ausgabe
Nextion 5" touchscreen Display